Fingerprint Reader Assembly - HP ProBook 450 G3 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly (includes cable and bracket)
Fingerprint reader insert (part of the Plastics Kit; for use in models without a fingerprint reader)
Before removing the fingerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Service doors (see
b. Optical drive
c. Hard drive
d. Keyboard (see
e. Top cover (see
Remove the fingerprint reader assembly:
1. Position the top cover upside-down.
2. Slide the fingerprint reader bracket toward the bottom of the top cover to remove it from the tabs (1),
and then lift the bracket off the fingerprint reader board (2).
Battery on page
Service doors on page
(Optical drive on page
(Hard drive on page 39)
Keyboard on page 48)
Top cover on page 53)
34).
35).
37)
Component replacement procedures
Spare part number
828417-001
828414-001
57