Basic Screen - Konica Minolta 2230 User Manual

Basic Operations

Basic Screen

The Basic screen displays after warm-up, when the power is turned on; when Auto Power Saver
mode is activated; when ECM password is set; or when Auto Reset mode is manually or
automatically restored. All copying selections can be initiated from the Basic screen, whether
selected with four Function keys, or conventional keys, i.e., Application, Output, and Job Memory.
When the Electronic Copy Monitor (ECM) is activated, a valid 5-digit user password, assigned by
the Key Operator, must be entered before copying can be performed. See p. 5-17.
If a Key Counter is required, the message PLEASE INSERT KEY COUNTER is displayed. Insert
a Key Counter.
All of the settings in the Basic screen, except Print Quantity, can be changed by the key operator in
the Initial Settings menu.
The Basic Screen
1 Position original document in the document feeder or on the platen glass.
The Basic screen displays when any key is pressed.
2 Press [START PRINT] to copy in the Full-auto mode.
The Function keys interact with the setting options of the Basic screen. The [OK] key
completes the selection made by the Function keys. Make copying selections, as required,
then press [START PRINT].
The following pages describe how to select basic functions.
Section 8 describes how to select Application functions.
NOTE: If the Basic screen displays ADJUSTMENT MODE in the message area, this means that the machine was left in the
service adjustment mode by a technician. If this occurs, please contact the technician to turn Off the mode; otherwise copying may
be adversely affected.
5-2 Basic Operations