Yamaha rivage pm10 Operation Manual page 25

Output Channels  Mixing Engine section
STEREO A/B
L R
PRE PRE
PRE
DIMMER
FILTER EQ DYNA
8 BAND
TALKBACK
HPF LPF DYNAMICS
PEQ
DIMMER
TALKBACK
KEY IN
STEREO
TO MATRIX
6
PRE FILTER
PRE DYNA
POST FADER
PRE FILTER
PRE DYNA
POST FADER
6
STEREO TO MATRIX
A signal can be sent from the STEREO channel to MATRIX buses 1 – 36.
• Send Point
This allows you to flexibly select the send point for each channel.
PRE POST
PRE FILTER POST FADER
PRE EQ POST ON
PRE DYNA
PRE DELAY
PRE FADER
Library
The "OUTPUT CHANNEL LIBRARY" lets you store and recall various output channel parameters.
MONO
STEREO B can be set to MONO. If it is set to MONO, the same signal is sent to L and R of STEREO
B.
This is also used as the CENTER channel of LCR. If it is set to MONO, the same signal is sent to L
and R of STEREO B.
LEVEL/
DCA1-24
PRE PRE POST POST
ON
DELAY FADER FADER ON
DELAY
BALANCE
Max.1000ms
STEREO TO MATRIX
PRE EQ
ON LEVEL
PRE FADER
POST ON
PAN/BAL
TO MATRIX
PRE EQ ON LEVEL
PRE FADER
POST ON
BUS TYPE: VARI
LCR
By using STEREO A as L/R and STEREO B (set to MONO) as CENTER, the two stereo buses can be
used as an LCR bus.
To
OUTPUT
PATCH
To
OUTPUT
PATCH
25
FAQ
CONTENTS
RIVAGE PM10 Operation Manual