Environmental Requirements; Hardware Description; Device Connections And Buttons - Watchguard AP300 Hardware Manual

Environmental Requirements

To safely install your WatchGuard AP device, we recommend that you:

Install the device indoors.

Make sure the device has adequate clearance for air flow and cooling.

Connect it to a surge-protected power supply to prevent damage from sudden power changes
Other environmental requirements:
Operating temperature
Operating relative humidity
Non-operating temperature
Non-operating relative humidity

Hardware Description

Device Connections and Buttons

Ethernet Network Interface
Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps.
Power Input
If you use the optional 12V AC adapter, connect the AC adapter to the device and to a power source.
Use only the WatchGuard AC power adapter for this AP device model.
If you use a PoE adapter other than the optional PoE adapter from WatchGuard, make sure that it
complies with the IEEE 802.3af PoE specification. Do not use a PoE adapter that is not IEEE 802.3af
compliant as it can damage your device.
Reset Button
Resets the WatchGuard AP device to factory-default settings. You must use a paper clip or other small
object to press the reset button through the small hole on the top of the device.

To reset the device to factory-default settings, with the AP device powered on, press and hold
the reset button for at least 5 seconds. After you reset the device, the Power/Status light flashes
Amber and Green to indicate that the AP device is not paired to a Firebox or XTM device.

To reboot the device, but not reset it to factory-default settings, press the reset button briefly
(less than 5 seconds).
You can see the current AP device firmware version in the Gateway Wireless Controller on the Firebox
or XTM device that manages the AP device.
Hardware Guide
32 to 104°F (0 to 40°C)
5% to 90% Non-condensing
-4 to 140°F (-20 to 60°C)
5% to 90% Non-condensing
Hardware Specifications
3