Battery Installation & Charging - AT&T CL80109 User Manual

Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery,
you can make and receive short calls. Place the handset in
the telephone base or charger when not in use. For optimal
performance, charge the handset battery for at least 16 hours
before use. See the table on page 31 for battery operating times.
If the battery is depleted, it may take approximately 10 minutes
to charge the handset before it shows LOW BATTERY. The screen
continues to show LOW BATTERY until the battery has charged
for approximately one hour; the backlight on the handset disables
when in LOW BATTERY mode.
Battery indicators
The screen is blank.
The screen shows
PLACE IN CHARGER
and flashes.
The screen shows LOW
BATTERY, flashes,
and the handset beeps.
The screen shows
HANDSET X.
Battery status
Battery has no charge
and the handset cannot
be used.
Battery has very little
charge and the handset
cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
5
Action
Charge until the screen
shows LOW BATTERY
(about 10 minutes).
Charge until the screen
shows LOW BATTERY
(about four minutes).
Charge until the screen
shows HANDSET X (about
one hour).
To keep the battery
charged, place it in the
telephone base or charger
when not in use.