Ports & Devices; Maintenance - Axis P5635–E User Manual

AXIS P5635–E PTZ Dome Network Camera
System Options
6. Click Connect.
To clear all recordings and data from the Axis product's folder on the designated share, click Clear under Storage Tools.
To avoid filling the share, it is recommended to remove recordings continuously. Under Recording Settings, select Remove recordings
older than and select the number of days or weeks.
To stop writing to the share and protect recordings from being removed, select Lock under Recording Settings.
Ports & Devices
I/O Ports
Port Status
The list on the System Options > Ports & Devices > Port Status page shows the status of the product's input and output ports.
Note
An Axis Multicable C I/O Audio Power 1 m/ 5 m (sold separately) or an Axis 10-pin Push-pull System Connector (sold
separately) is required when connecting I/O devices to the Axis product. See Axis Multicable C I/O Audio Power 1 m/ 5 m (sold
separately) on page 66 and Axis 10-pin Push-Pull System Connector (sold separately) on page 67

Maintenance

The Axis product provides several maintenance functions. These are available under System Options > Maintenance.
Click Restart to perform a correct restart if the Axis product is not behaving as expected. This will not affect any of the current
settings.
Note
A restart clears all entries in the Server Report.
Click Restore to reset most settings to the factory default values. The following settings are not affected:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
• the system time
• the IEEE 802.1X settings
• uploaded applications are kept but must be restarted
Click Default to reset all settings, including the IP address, to the factory default values. This button should be used with caution. The
Axis product can also be reset to factory default using the control button, see Reset to Factory Default Settings on page 58.
To test the product's PTZ mechanics, click Test under PTZ Status.
For information about firmware upgrade, see Upgrade the Firmware on page 60.
56