Table of Contents
Advertisement
Connecting the Infrared (IR) Emitter for the
Home Theater connection
Use this hook-up to:
•
connect a Mitsubishi AV receiver to your TV for the Home
Theater function.
equipment you will need (included with TV):
IR Emitter
IR emitter assembly
two strips of double-sided adhesive foam tape (not pictured).
Included with your television is an IR emitter assembly. There
are two separate IR transmitter lenses connected to the end of
the plug. One IR transmitter is used to send control signals
from your TV to your AV receiver, the other transmitter will not
be used.
procedure
† Insert the IR emitter into the IR HOME THEATER jack at the
back of your TV as shown in the illustration on the previous
page.
¢ Arrange a cable line coming from an IR emitter to the AV
receiver. The cable can be laid on top of the AV receiver. For
permanent installation use the adhesive tape to secure the
bottom of the transmitter to the anchoring object you choose.
£ Place an IR transmitter lens (small clear sphere resembling a
tiny light bulb) so that it directly faces the remote control
infrared receiver(s) of your AV receiver.
Infrared receivers are usually located on the front face of the
AV receiver. Consult the owner manual of your receiver to
ensure accurate positioning of the Mitsubishi IR transmitter
lens.
® Place the unused transmitter lens in an out-of- the-way loca-
tion.
Additional Component Connections
Transmitter Lenses
33
Advertisement
Table of Contents
