Set Up Instructions - Stamina 40-0041GG Owner's Manual

SET UP INSTRUCTIONS

Place the Mini Stepper in the area where it will be used. It is recommended that the Mini Stepper be
placed on an equipment mat. The maximum operation dimensions of the Mini Stepper is approximately
15.3 inches long x 12 inches wide x 12 inches tall. (These dimensions may vary up to one inch.) Make
sure that adequate space is available for access to passage around and emergency dismount from the
Mini Stepper. A minimum of 20 inches on both sides and 20 inches either behind or in front of the Mini
Stepper is required for safe operation.
LEVELING: Adjust the location of Mini Stepper so the stepper sits on the floor without rocking.
MOVING: The Mini Stepper must be lifted to be moved. Grasp the Front and Rear Stabilizers to move
the Mini Stepper. Do not use the PEDAL ARMS(10, 14) to move the Mini Stepper. The
PEDAL ARMS(10, 14) will move and the SHOCK(26) may pinch your hand or fingers.
FUNCTION INSPECTION:
NOTE: Always make sure that the CABLE(4) is properly seated in the groove on the PULLEY(5) before
using the Mini Stepper.
Visually inspect the Mini Stepper to verify that assembly is as shown in the above illustration. Check the
function of the Mini Stepper. Stand on the foot pedals and slowly move your highest foot downward and
follow the natural path of the machine. The SHOCKS(26) should provide resistance for your workout.
CAUTION: Locate and read the CAUTION LABEL(28) on the Mini Stepper. Make sure that all users
read the CAUTION LABEL(28) before using the product.
Rear Stabilizer
7
Front Stabilizer
Equipment Mat
(not included)