Assembly Instructions; Pulley Bracket - Stamina 40-0041GG Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Service section and order the part needed,
e-mail us at customerservice@staminaproducts.com, or call us toll free at 1-800-375-7520 (in the
U.S.). Our Customer Service Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central
Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
STEP 1
Refer to detail view A. The PULLEY BRACKET(3) is tied to the MAIN FRAME(1) with a nylon strap for
packing. Use scissors to carefully cut and remove the nylon strap.
STEP 2
Refer to the illustration below. Lift the RIGHT PEDAL ARM(10) up as shown. Place the CABLE(4) in the
groove on the PULLEY(5) properly, then press the RIGHT PEDAL ARM(10) down.
6
A.
Nylon Strap