Setup Tcp/Ip; Boot Method - Brother NC-9100h Network User's Manual

Setup TCP/IP

This menu has nine sections: Boot Method, IP Address, Subnet
Mask, Gateway, Host Name, WINS Config, WINS Server, DNS
Server and APIPA.

BOOT Method

1
(For MFC) Press
(For DCP) Press
2
Press
DHCP .
3 Set
Press .
4 Stop/Exit
Press
Static mode
In this mode the DCP/MFC IP address must be manually assigned.
Once entered the IP address is locked to the assigned address.
Auto mode
In this mode, the DCP/MFC will scan the network for a DHCP server,
if it can find one, and if the DHCP server is configured to allocate an
IP address to the DCP/MFC, then the IP address supplied by the
DHCP server will used. If no DHCP server is available, then the DCP/
MFC will scan for a BOOTP server. If a BOOTP server is available,
and it is configured correctly, the DCP/MFC will take its IP address
from the BOOTP server. After it is initially powered ON, it may take a
few minutes for the DCP/MFC to scan the network for a server.
The DCP/MFC supports "POWER SAVE mode" and you are
using the AUTO Boot mode, POWER SAVE must be set to
OFF.
10 - 2 FRONT PANEL SETUP MENU
Menu 6
, ,
Menu 4
, ,
or to select Auto , Static , RARP , BOOTP or
.
1 1
, .
1 1
, .