Reloading Process - Brother NC-9100h Network User's Manual

5
Netware GET from a server
You must have a Netware server on your network (running IPX/
SPX) and you must store the new firmware file in the SYS/Login
directory of the server. In this case, your PC makes the Print/Fax
server read the firmware data from the assigned Netware
server, the Print/Fax server attaches to the Netware server and
reads the firmware itself.
AFTER SENDING FIRMWARE TO THE MFC, DO NOT
TURN OFF THE MFC UNTIL AFTER THE MFC HAS
PERFORMED AN AUTOMATIC RESTART.

Reloading process

The Data LED on the printer control panel will blink during the
firmware file loading process. During programming process, the
backlight on the printer's LCD goes off, and Erase xxxxxx and Write
xxxxxx will be indicated alternately on the LCD. After the firmware
update is completed, the printer will re-start automatically. DO NOT
TURN OFF THE PRINTER DURING THESE PROCESSES.
If the Data LED does not stop blinking after about two minutes, check
to make sure that you correctly entered all parameters and that your
network connections are good. Then power the print server/printer
off and then on again, to retry the download.
If you encounter problems upgrading the firmware and you
find that the network portion of the printer no longer functions,
you should try re-programming the print server by using the
COPY command from the DOS prompt of your PC. To do
this, connect a parallel cable between your PC and printer
and use the command COPY filename LPT1:/B (where
filename is the new firmware file).
A - 6 APPENDIX