Network; Wan - TP-Link TL-WR841N User Manual
300mbps wireless n router
Hide thumbs
Also See for TL-WR841N:
- User manual (184 pages) ,
- Quick installation manual (30 pages) ,
- Setup manual (17 pages)
Table of Contents
Advertisement
Note:
1)
The WPS LED on the router will light green for five minutes if the device has been
successfully added to the network.
2)
The WPS function cannot be configured if the Wireless Function of the router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
4.5
Network
Figure 4-5 the Network menu
There are three submenus under the Network menu (shown in
and LAN. Click any of them, and you will be able to configure the corresponding function.
4.5.1
WAN
Choose menu "Network→WAN", you can configure the IP parameters of the WAN on the screen
below.
1.
If your ISP provides the DHCP service, please choose Dynamic IP type, and the router will
automatically get IP parameters from your ISP. You can see the page as follows (
TL-WR841N/TL-WR841ND
Figure 4-6 WAN - Dynamic IP
-23-
300Mbps Wireless N Router
4-5): WAN, MAC Clone,
Figure
):
Figure 4-6
Advertisement
Table of Contents
