Table of Contents
Advertisement
that the foam rubber sealing ring is on the
centering pin.
5.
Release the catch at the top on the con‐
nector of the connecting line and remove
the connector from the bulb holder.
Replacing the bulbs
1.
Loosen the three fasteners, arrows 1, on
the bulb holder and remove the bulb holder
from the tail lamp, arrow 2.
2.
Press the defective bulb gently into the
socket, turn counterclockwise and remove.
3.
Proceed in the reverse order to insert the
new bulb and attach the bulb holder. Make
sure that the bulb holder engages in all fas‐
teners.
Installing the tail lamp
1.
Connect the connecting line to the tail
lamp and secure the bulb holder in the clip.
2.
Make sure that the sealing ring is on the
centering pin and that it is not damaged.
3.
Position and firmly press the outer part of
the tail lamp onto the rubber mount, ar‐
row 1, and the inner part onto the screws,
I n f o r ma t i o n P r o v i d e d b y :
Online Edition for Part no. 01 40 2 960 574 - II/15
Replacing components
arrow 2. Make sure that the tail lamp en‐
gages in the rubber mount.
4.
Screw the two nuts tight and mount the
cover.
Lights in the tailgate
General information
Follow general instructions, refer to page 210.
Reversing lights: 16-watt bulb, PW16W.
Inner brake lights: 21-watt bulb, H21W
Accessing the lights
Slide the cover outwards, arrow, and remove.
Mobility
217
Advertisement
Table of Contents
