Table of Contents
Advertisement
Mobility
In the wheel house, loosen the two brackets
and remove the cover.
Turn signal
24-watt bulb, PY24W
1.
If necessary, pull the inside trim of the
wheel house slightly inward. Turn the bulb
holder counterclockwise and remove.
2.
Press the bulb gently into the socket, turn
counterclockwise and remove.
3.
Install the new bulb and bulb holder in re‐
verse order of removal.
4.
Attach the cover to the wheel house.
212
Replacing components
Online Edition for Part no. 01 40 2 960 574 - II/15
Low beams
55-watt bulb, H7.
1.
Turn the lid counterclockwise and remove.
2.
Tilt the bulb down and then up to loosen it
from the holder and remove.
3.
Pull the connector off the bulb.
4.
Attach the connector to the new bulb.
5.
First insert the bulb at the top with the
strap, arrow 1, and then press down firmly,
arrow 2. Make sure that the bulb snaps into
place.
6.
Close the headlight housing with the lid.
Make sure that the lid engages.
7.
Attach the cover to the wheel house.
I n f o r ma t i o n P r o v i d e d b y :
Advertisement
Table of Contents
