Outer Elements Disassembly - Saeco Syntia Service Manual

SYNTIA
7.1.

Outer elements disassembly

3
Saeco International Group
1
4
6
7
When refitting the machine cover, take great care not
to scratch the keypad cover.
Put a sheet of paper on the keypad cover (see photo)
before refitting the machine cover and slide it out at
the end of assembly
Rev.01 February 2010
Disassembling the Top cover
1) Remove the grounds drawer,
water tank, coffee container lid,
drip tray, brewing unit, steam
wand covering cap, pannarello
and control knob cover
2) Unscrew the screws shown
and remove the finger protection
2
device and coffee hopper
3) Unscrew the screw shown and
extract the control knob
4/5) Unscrew the screw shown
and extract the coffee dispenser
fixed support by lifting it upwards
5
6) Unscrew the screws shown
located inside the compartments
containing the water tank and
grounds drawer
7) Lift the lid and disconnect the
earth wire shown
07 DISASSEMBLY
Page 01 / 09