Cleaning And Maintenance - Peg-Perego triplette sw Instructions For Use Manual

Hide thumbs Also See for triplette sw:
Table of Contents

Advertisement

Available languages

Available languages

• CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
• DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE MUST
BE TAKEN IF UNIT IS USED ON STAIRS
OR ESCALATORS.
• DO NOT USE THE PRODUCT IF IT HAS
BROKEN OR MISSING PARTS.
• DO NOT USE NEAR FIRE OR EXPOSED
FLAME.
• NOTICE: THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
instructions for use
ASSEMBLING THE WHEELS
1• Remove the four protection caps (two round
ones and two square ones) from the chassis
while it is still folded up, as shown in the figure.
2• Mount the front wheels with the chassis folded,
pressing on the attachment lever (figure A) and
inserting the hub onto the rod (figure B). Check
to make sure the wheels are correctly attached
by pulling them in opposite directions.
3• Repeat the same operation on the rear wheels
as for the front wheels (steps A and B).
• Check to make sure the brake gear is correctly
installed.
BRAKE
4• To set the brake on the chassis, lower the brake
bar on the rear wheels, as shown in the figure.
OPENING THE CHASSIS
• Set the brake while the chassis is still folded up.
5• Lift the handlebar in the direction shown by the
arrow.
6• Press the handlebar downwards until it clicks
into the final position.
7• To make sure the chassis is correctly open,
check the illustration.
BASKET
8• The basket goes at the base of the chassis, as
shown in the figure.
9• The basket fastens to six different points. First,
fasten it to the four buttons in the front and
back, as shown in figure A and B. Then fasten
the two straps to the chassis pipe, as shown in
figure C.
STEERING WHEEL
10• To allow a good grip, the steering wheel can be
adjusted to four different positions by pressing
on the button shown in the figure.
SWIVEL WHEELS
11• The practical steering wheel has a lever for
swiveling the front wheels. Move the lever on
the steering wheel to the right to swivel the
front wheels, as shown in figure A. To set the
wheels on stationary, use the lever on the left,
as shown in figure B.
REMOVING THE WHEELS
12• To remove the wheels, press the lever on the
center of the wheel, as shown in the figure, and
pull the wheel towards yourself.
FOLDING UP THE CHASSIS
• Set the brake and unfasten the seats.
13• To fold up the chassis, lift the lever on the large
handle as shown in the figure, unfastening the
handlebar and moving it slightly forward.
14• Use your left foot to press the safety lever
downward to loosen the handlebar, as shown
in the figure.
15• Turn the handlebar downward, as shown in the
figure.
ganciomatic system
To meet your specific needs, the Ganciomatic
System allows you to fasten the car seat or the
carrying seat to the Triplette SW chassis. Please
follow the instructions for combining various
products.
TRIPLETTE SW + 3 CARRYING SEATS
NOTICE:
• To keep the product steady, we recommend
installing all three carrying seats at all times.
• If for any reason Triplette SW is used with
only one or two occupants, we recommend
fastening all three carrying seats securely to the
chassis in any case. Place the child or children in
the seats nearest the steering wheel.
16• For instructions on attaching the product to
the chassis and detaching it, see the instruction
manual supplied with the seat.
Figures A and B show two ways the seat can be
fastened to the chassis.
TRIPLETTE SW + 3 PRIMO VIAGGIO CAR SEATS
17• The figure shows how to attach the product to
the chassis (turned towards the mother).
cleaning & maintenance
• Your product requires only minimal
maintenance. Cleaning and maintenance
operations must be performed only by adults.
• Be sure to keep all moving parts clean,
lubricating them with light oil if necessary.
• Dry off metal parts to prevent rusting.
• Regularly clean the plastic parts with a damp
cloth. Do not use solvents or similar products.
• Remove any dust and sand from the wheels.
• Protect the product against smog, water, rain
and snow. Continued and extended exposure

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents