Brother TD-4000 User Manual page 16

13
STEP 1 Getting started
5
Position the end of the RD Roll to
just below the black plastic cutter
guard.
6
Close the RD Roll compartment cover.
7
Press and hold the ON/OFF button ( ) to turn the TD-4000/4100N
on.
Die-cut label
8
Press the Feed button.
The printer will feed the label to the correct starting position.
You are now ready to print.
Continuous length label
8
Press the Feed button twice and then the Cut button.
The printer will feed the label to the correct starting position.
You are now ready to print.
If the media does not load correctly, trim off some of the media to produce a straight
edge and repeat this loading procedure.
Black plastic
cutter guard