Planar PS4661T User Manual page 50

Advanced Menu
Baud Rate
Smart Light Control
Wake Up From Sleep
Ethernet Setup
Factory Reset
50
Options: 115200, 38400, 19200, 9600
Default: 19200
Options: Off, DCR, Light Sensor
Default: Off
Allows you to configure the display to "wake up" when it receives a digital signal
through the DisplayPort, HDMI or DVI connectors. With VGA Only, the display can
only "wake up" by sending an analog video signal through the VGA connector.
Options:
Never Sleep - The display will never enter a power saving mode.
VGA Only - The display will enter a power saving mode if it cannot sync for five
minutes with the DisplayPort, HDMI or DVI. If the sync is present, the display
will "wake up" again.
VGA, Digital, RS-232 - The display will enter a power saving mode if it cannot
sync for five minutes with any source.
Default: VGA Only, Digital, RS-232
Configure Network settings.
Refer to "LAN Control" on page 52 for detailed settings.
Restores all settings to their defaults.
Options: No, Yes
Default: No
PS4661T and PS5561T User Guide