Receiver Controls And Connectors - Shure UHF-R User Manual

Shure UHF-R Wireless

Receiver Controls and Connectors

17
17
UR4S+
Wireless Receiver
with Audio Reference Conpanding
sync
 SYNC Infrared (IR) port. Transmits group, channel, and other
settings to a transmitter. See page 16.
 Squelch LEDs.
Blue (On) = Transmitter signal detected
•
Off = no signal or signal squelched because of poor reception or
•
no tonekey
NOTE: The receiver will not output audio unless at least one
blue LED is illuminated.
 RF LEDs. Indicate RF signal strength from the transmitter at
each antenna and diversity condition.
Amber = normal
•
Red = overload (greater than –25 dBm)
•
4 Audio LEDs. Indicate audio signal strength from transmitter.
Green = signal present
•
Yellow = normal peak
•
Red = overload
•
To correct this level, adjust the transmitter gain.
5 Indicates the name and range of receiver frequency band.
 LCD Interface. Provides a convenient way to program the
receiver from the front panel (see detail on next page).
7 Monitor. 1/4" output jack and volume knob for headphones.
Monitor Clip LED indicates headphone audio is clipping.
•
Dual models: Push the knob to switch from receiver one to
•
receiver two.
Note: The diagram above represents the UR4S single channel receiver. The UR4D dual channel receiver is functionally identical to the UR4S, adding a
second LCD interface and set of output jacks for channel 2.
3
antenna B in
RF B out
balanced low Z
line
12.7V out
mic
150mA
9 10 11 18 12
2 4 5
RF Audio XX YYY-ZZZ MHz
OL
A B
receiver outputs
200Ω
lift
GND
13 14 15 16
 Power switch. Powers the unit on and off.
 AC mains power input, IEC connector. 100–240 Vac.
 AC mains power passthrough (unswitched). Use IEC
extension cables to connect up to five UR4+ receivers to a
single AC power source.
 Diversity antenna inputs A and B.
Note: Antenna inputs are DC biased. Use only antenna
combiners and accessories listed in page 21. Some types of
antenna splitters or other products may short the DC power
and damage the receiver.
 Mic/Line switch. Changes output level 30 dB (XLR output only).
 Electrically balanced XLR output jack
 Lift/GND switch. Lifts ground from Pin 1 of the XLR connector
(default = GND).
 Impedance balanced 1/4" output jack (200Ω)
 RJ-45 jack for Ethernet network interface. Accepts both regular
and "ruggedized" RJ-45 plugs.
 Temperature-activated fan ensures top performance in high
temperature environments. Clean fan screen as needed to
remove dust.
 The RF distribution ports pass the RF signal from one receiver to
the next, allowing a maximum of 10 receivers to share a single
pair of antennas.
8
Navigate
Monitor
Control
OFF
ENTER
push
Monitor Clip
EXIT
push
6 7
networking
antenna A in
network
activity
12.7V
ethernet
150mA
RJ-45
11
POWER
8
RF A out
out
18