Assistants Mode - ABB ACS350 User Manual

76

Assistants mode

When the drive is first powered up, the Start-up Assistant guides you through the
setup of the basic parameters. The Start-up Assistant is divided into assistants, each
of which is responsible for the specification of a related parameter set, for example
Motor Set-up or PID Control. The Start-up Assistant activates the assistants one
after the other. You may also use the assistants independently. For more information
on the tasks of the assistants, see section
In the Assistants mode, you can:
• use assistants to guide you through the specification of a set of basic parameters
• start, stop, change the direction and switch between local and remote control.
How to use an assistant
The table below shows the basic operation sequence which leads you through
assistants. The Motor Set-up Assistant is used as an example.
Step Action
1. Go to the Main menu by pressing
EXIT
by pressing
2. Go to the Assistants mode by selecting ASSISTANTS on the menu with keys
and
3. Select the assistant with keys
If you select any other assistant than the Start-up Assistant, it guides you
through the task of specification of its parameter set as shown in steps
below. After that you can select another assistant on the Assistants menu or exit
the Assistants mode. The Motor Set-up Assistant is used here as an example.
If you select the Start-up Assistant, it activates the first assistant, which guides
you through the task of specification of its parameter set as shown in steps
and 5. below. The Start-up Assistant then asks if you want to continue with the
next assistant or skip it – select the appropriate answer with keys
, and press
same question about the next assistant, and so on.
4. • To specify a new value, press keys
• To ask for information on the requested parameter, press key
help text with keys
Control panels
MENU
if you are in the Output mode, otherwise
repeatedly until you get to the Main menu.
ENTER
, and pressing .
and
SEL
. If you choose to skip, the Start-up Assistant asks the
and . Close the help by pressing
Start-up Assistant
SEL
, and press .
and .
. Scroll the
?
EXIT
on page 95.
Display
LOC MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
00:00
LOC ASSISTANTS
Start-up assistant
Motor Set-up
Application
Speed control EXT1
Speed control EXT2
EXIT 00:00
LOC PAR EDIT
9905 MOTOR NOM VOLT
220 V
4. and 5.
EXIT 00:00
LOC CHOICE
Do you want to
4.
continue with
application setup?
Continue
and
Skip
EXIT 00:00
LOC PAR EDIT
9905 MOTOR NOM VOLT
240 V
EXIT 00:00
LOC HELP
Set as given on the
.
motor nameplate.
Voltage value must
correspond to motor
D/Y connection.
EXIT 00:00
1
ENTER
1
SEL
SAVE
OK
SAVE