Table of Contents
Advertisement
Remote Control, continued
1
2
3
5
6
7
8
9
10
11
12
13
1
15
16
Figure 1. Remote Control Overview
Battery Installation
Figure 2
Installing the Batteries:
1. Remove the remote control's back cover by gently
pressing the ribbed tab in the direction of the arrow
and sliding off the cover.
2. Load the batteries, making sure the polarities (+) and
(-) are correct. For best results, insert the negative (-)
side first.
17
18
19
20
21
Figure 2. Operation: Installing the Batteries
22
Care
23
For Best Results from the Remote Control:
2
•
Be within 20 feet of the equipment.
•
Do not press two or more buttons at the same time
25
unless instructed.
26
•
Do not allow unit to get wet or become heated.
•
Avoid dropping on hard surfaces.
27
•
Do not use harsh chemicals to clean. Use only a soft,
28
lightly moistened cloth.
•
Do not mix new and old batteries.
29
•
Do not heat, take apart, or throw batteries into fire.
30
•
Use only AA alkaline batteries.
31
Hint: If the remote is in the TV layer and does
not function, press POWER and 935 to reset the
32
remote.
33
Sleep Timer
Setting the Sleep Timer:
3
1. Press SLEEP on the remote control.
2. Each additional press of SLEEP increases the time
displayed by 30 minutes up until the maximum value
of 120 minutes.
3. After five seconds of inactivity, the message will
disappear.
4. Press SLEEP to view the time remaining before the
timer turns the TV off.
Cancelling the Sleep Timer:
1. Press SLEEP to display the on-screen message.
2. Press SLEEP repeatedly until OFF is displayed.
Note: After five seconds of inactivity, the mes-
sage box disappears.
Chapter 1. Television Overview
17
Hide quick links:
Advertisement
Table of Contents
