Windows Nt Driver Software; Installing The Driver - NETGEAR GA620 Reference Manual

This chapter provides information about the Windows NT driver. Use the Windows NT driver
software if you installed the NETGEAR Model GA620 Gigabit Ethernet Card in a PC that is
operating in a Windows NT environment.
This chapter also gives directions for performing the following procedures:
• Installing the driver software (this page)
• Changing the driver configuration after the driver software is installed
• Updating or reinstalling the driver software
• Moving the network card and removing the driver software

Installing the Driver

Your Model GA620 Gigabit Ethernet Card must be physically installed in the server before
installing the software driver. If you are installing more than one Model GA620 Gigabit Ethernet
Card, you must perform the following procedure for each card.
To install the driver software if you are operating in a Windows NT environment:
Start your Windows NT system and log in.
1.
You must have Network Administrator privileges to install the driver software.

Windows NT Driver Software

Windows NT Driver Software
(page 3-6)
Chapter 3
(page 3-6)
(page 3-7)
3-1