Appendix B: Specifications - Mitsubishi WD-62530 Owner's Manual

Appendix B: Specifications

Picture Technology
Projection System
Lamp
Reception
Channel Frequency Reception
Channel Type*
* Note for Digital Channels: The channel numbers displayed on screen are determined by the broadcaster or cable company and can
vary from the standard frequency number. If there is no channel-number information provided by the broadcaster or cable company, the
TV creates a channel number. The created channel number uses the frequency number as the main channel number and the program
number as the sub-channel number.
Inputs
Description
Antenna/Cable input
HDMI (digital video/audio)
WD-52531 & WD-62531:
WD62530:
Video (one side, two rear)
S-Video (one side, two rear)
Component Video (Y/Pr/Pb)
Audio Inputs
WD-52531 & WD-62531:
WD62530:
3 LCD, 0.7" x 3, 1280 x 720 pixels
132-watt high-pressure mercury discharge
Over-the-Air: VHF 2–13, UHF 14–69
Analog Cable: 1–125
Digital Cable: 1–135
Over the Air:
Cable:
Qty. Signal Type
2 RF
HDMI EIA-861B standard
2
for digital audio and video
1
3
NTSC 480i only
3
EIA-770.1 & EIA 770.2
480i, 480p, EIA 770.3
2
720p and 1080i (video
standards)
6 pairs
analog left and right audio RCA Pin Plug 500 mV (full scale), 43-k ohm
5 pairs
Analog NTSC, Digital ATSC with sub-channels (all 18 video
formats)
Analog NTSC (non-scrambled)
Digital QAM 64 and 256 with sub-channels (non-scrambled)
Input Specifications
F connector, 75-ohm
HDMI standard connector
Video: 480i, 480p, 720p, 1080i
Audio: PCM stereo
Note: Not for use with personal computers.
(Composite) Video: RCA Pin Plug, 1.0 V p-p,
1.0 V p-p, 75 ohm
S-Video: Four-Pin DIN Plug
Y: 1.0 Vp-p 75-ohm
C: 0.286 Vp-p (burst signal), 75-ohm
RCA Pin Plug (EIA-770.3 Standard Levels and
Timing)
Y: 1.0 Vp-p (includes sync), 75-ohm
Pr: 700 mV p-p, 75-ohm
Pb: 700 mV p-p, 75-ohm
Appendices Appendices
73 73