Split Screen - Mitsubishi WD-62530 Owner's Manual

Split Screen

Split Screen allows you to view pictures from two different
sources at the same time. Split Screen is available when
you have video sources connected to the TV in addition to
any connections to ANT 1 and ANT 2.
Operation
Split Screen Operations
Turn Split Screen on or off
Switch the sound source between main and
sub-picture.
Check which picture is the sound source.
Change the source of the sub-picture.
Change sub-picture channel (when the input
source is ANT 1 or ANT 2.)
Freeze or unfreeze the sub-picture image.
Change the size of the main and sub-pictures.
Make the sub-picture fill the screen.
Display choices. Press the FORMAT key repeatedly while
in Split Screen mode to view different display options.
"SPLIT" appears under the
Video icon to distinguish
this menu from the Input
Selection menu.
Figure 4. Change the source of the sub-picture with the
Split Screen Input Selection menu.
Instructions
Press SPLIT.
Press
the source as either the main picture (left) or the sub-picture
(right). The sound source is the side you can control with
the remote control.
Press INFO. The speaker icon appears in the information display to
indicate the active picture.
1. Press
2. Press INPUT and move the highlight to the icon for the input you
wish to view in the sub-picture (see figure 4).
3. Press ENTER to make the change.
Grayed-out input icons are unavailable as Split Screen sources or
with the current source.
Press
CH
Press
Repeatedly press FORMAT to cycle through picture sizes. See the
following page for sample displays.
1. Press
2. Press SPLIT to close Split Screen mode.
Choice of Split Screen
sub-Picture Sources
Chapter 3. TV Operation
or . The speaker icon appears briefly to indicate
to switch the sound source to the sub-picture.
to make the sub-picture the sound source, then press
/ .
(PAUSE). Press
again to return to normal video.
to make the sub-picture the sound source.
Split Screen is unavailable if:
• Your only inputs are ANT 1 and ANT 2.
• The main and sub-picture can not both
have HDMI inputs
• Either picture source is a 1080p signal from
an HMDI jack.
IMPORTANT
37