Replacing The Developer - Kyocera FS-1920 Service Manual

(2) Replacing the developer

To remove the developer unit from the printer for shipment or replacing to a new one, it should be handled following the
instructions below.
After the replacement, new developer needs to be initialized. See page 1-4-10.
Shipping the developer
The printer is supplied with a plastic bag that should be retained for future shipment of the developer.
1. To pack the developer in the packing carton, first flap down the magnet roller protective cover.
2. Put the developer into the supplied plastic bag.
3. Put the developer on the developer install position of packing carton.
Developer
Magnet roller
protective cover
Figure 1-4-6
2FP/2FY/2FR
Plastic bag
(A)
1-4-13