Kyocera FS-1920 Service Manual page 53

Code
0550 Non-supported duplexer is installed
·Non-supported duplexer DU-60 is
installed
Paper feeder PF-60 [top] with wrong
0560
firmware version is installed
·The code that identifies the firmware
version was out of range.
0570 Paper feeder PF-60 [middle] with
wrong firmware version is installed
·The code that identifies the firmware
version was out of range.
Bulk paper feeder PF-8E with wrong
firmware version is installed
·The code that identifies the firmware
version was out of range.
0580 Paper feeder PF-60 [bottom] with
wrong firmware version is installed
·The code that identifies the firmware
version was out of range.
Optional duplexer DU-61 side regis-
1200
tration error
· Side registration home position error of
optional duplexer DU-61.
Contents
Causes Check procedures/corrective measures
DU-60 is in- Replace duplexer DU-60 for DU-61.
stalled.
Wrong firmware Change the main board with the one hav-
version is used ing the correct firmware in paper feeder
on the main PF-60.
board in paper
feeder PF-60.
Wrong firmware Change the main board with the one hav-
version is used ing the correct firmware in paper feeder
on the main PF-60 or bulk paper feeder PF-8E.
board in paper
feeder PF-60 or
bulk paper feeder
PF-8E.
Wrong firmware Change the main board with the one hav-
version is used ing the correct firmware in paper feeder
on the main PF-60.
board in paper
feeder PF-60.
Defective gate Replace engine board (KP-1081). See
array U7 on the page 1-6-20.
engine board
(KP-1081).
Improper installa- Follow installation instruction carefully
tion between again.
printer and op-
tional duplexer, or
each optional
unit.
Defective har- Replace harness (S03022).
ness (S03022)
between engine
board and op-
tional unit inter-
face connector.
Improper connec- Remedy.
tor insertion.
Defective optional Refer to the optional duplexer DU-61's
duplexer DU-61. service manual.
2FP/2FY/2FR-2
Remarks
1-5-3