Network - Denon AVR-X2000 Owner's Manual

Contents

Network

To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set "DHCP" to "On" (use the default setting). This allows this unit to use your home network (LAN).
If you assign an IP address for each device, you must use the "IP Address" setting to assign an IP address to this unit and enter the information about
your home network (LAN) such as the gateway address and subnet mask.
Information
Display network information.
Friendly Name / DHCP On or Off / IP Address / MAC Address
%
• MAC Address is required to make a vTuner account.
IP Control
Enables network communication in standby power mode.
Off In Standby (Default) : Suspend network function during standby.
Always On : Network is on during standby. Main unit operable with a
network compatible controller.
%
• Set to "Always On" when using the web control function.
NOTE
• When "IP Control" is set to "Always On", it consumes more standby power.
Front panel Display
Connections Playback
Rear panel
Settings
Friendly Name
The Friendly Name is the name of this unit displayed on the network. You
can change the Friendly Name according to your preferences.
2 Edit Name
Edits Friendly Name.
%
• The default Friendly Name on first use is "Denon AVR-X2000".
• Up to 63 characters can be input.
• For character input, see page 121.
2 Set Defaults
Restores Friendly Name, which you had changed, to the default setting.
156
Remote
Tips Appendix
Index