The Back Panel; Figure 3-2: Back Panel - Linksys WAP54GP User Manual

Wireless-G Access Point with Power Over Ethernet

The Back Panel

The Access Point's Ethernet network and power ports, as well as the Reset button, are located on the back panel.
Ethernet Port The Ethernet network port connects to an Ethernet network device, such as a switch or router.
Reset Button There are two ways to Reset the Access Point's factory defaults. Either press the Reset
button, for approximately ten seconds, or restore the defaults using the Access Point's Web-
based Utility.
IMPORTANT: Resetting the Access Point will erase all of your settings
(including wireless security, IP address, and power output) and replace them
with the factory defaults. Do not reset the Access Point if you want to retain
these settings.
Power Port The Power port connects to the Access Point's power adapter. (This port will not be used if you
are using Power Over Ethernet.)
Chapter 3: Getting to Know the Wireless-G Access Point with Power Over Ethernet
The Back Panel
port: the connection point on a computer or
networking device used for plugging in
cables or adapters

Figure 3-2: Back Panel

7