Pioneer DJM-2000 Service Manual page 47

5
9. After updating is completed, a completion message will be displayed in the dialog box. After checking that 100% is
displayed on the DJM-2000, click on OK. Restart the DJM-2000.
<If an Error is Generated>
An error may be generated while updating of the application is in progress, for the reasons described below.
If an error is generated, perform the above procedures again.
• The updater application is started on the PC without a network environment.
• The updater files cannot be found.
• Communication is interrupted during updating, because of a defective LAN cable, etc.
<Reference>
In a case of the Auto IP setting in a Windows environment, it may take 1 minute or longer until the network communication is
established after the DJM-2000 is connected with the PC. In such a case, the current status can be confirmed on the
Windows PC.
1. When the DJM-2000 is not connected with the PC
2. When the DJM-2000 that is started in Update mode is connected with the PC via a network cable
Network communication has not been established yet. Updating of the firmware of the DJM-2000 cannot be executed
even if the updater application is started.
Note: After the network cable is disconnected, the indication will return to 1.
3. When an IP address is assigned with Auto IP
Updating of the firmware of the DJM-2000 can be executed by starting the updater application.
5
6
DJM-2000
6
7
7
8
A
B
C
D
E
F
47
8