D-Link DSL-4320L User Manual page 91

Section 4 - Configuration
Select PPPoE if your Internet connection requires you to enter a username and password. This information is provided by your Internet Service
Provider (ISP).
PPPoE Session: Choose Share with IPv4 to re-use your IPv4 PPPoE username and
password, or Create a new session.
If you selected Create a new session above, enter the PPPoE
Username:
username provided by your ISP here.
Password: If you selected Create a new session above, enter the PPPoE
password provided by your ISP here.
Select Static IP if your ISP assigned you the IP address, subnet mask,
Address Mode:
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP address provided by your ISP (Static IP only).
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Select either Obtain DNS server address automatically or Use the
DNS Type:
following DNS address.
Primary DNS If you selected Use the following DNS address above, enter the
Server: primary DNS server address.
If you selected Use the following DNS address above, enter the
Secondary DNS
Server: secondary DNS server address.
Enable DHCP- Enable or disable prefix delegation services.
PD:
D-Link DSL-4320L User Manual
PPPoE
87