Biostar M6VCG User Manual page 81

Chapter 4
 != -
 ( .

No power to monitor.
Monitor not connected to
computer.
Network card I/O address
conflict.
 ( .

Memory problem, display
card jumpers not set
correctly.
Computer virus.
!"#$
 2(
Check the power
connectors to monitor and
to system. Make sure
monitor is connected to
display card, change I/O
address on network card if
applicable.
See instructions above.
See instructions above.
!"#$
 2(
Reboot computer.
Reinstall memory, make
sure that all memory
modules are installed in
correct sockets. Check
jumper and switch
settings on display card.
See display card section
for information on
settings.
Use anti-virus programs
(mcAfee, E-Prot, etc) to
detect and clean viruses.
4-6
Trouble Shooting
(./(2
(./(2