Listening To The Radio; Connecting To A Network - Denon DN-700AVP User Manual

Listening to the Radio

1. If DN-700AVP is powered off, press the Power button to power it on.
2. Use the Source Select knob to choose Tuner. The audio from the broadcast will start automatically.
Important: Make sure you have properly connected the FM antenna.
3. To select a radio station, use the Tuner -/+ buttons on the unit or the Tuning -/+ buttons on the remote control. Hold either the Tuning +
or Tuning – button down for 2 seconds to scan and stop at the next radio station with a strong signal.
Note: RDS is a method for the transmission of additional information via VHF stations. For example, the name of the station
broadcasting, the name of the program, or the type of program will be shown on the multifunction display. It can only function if the local
broadcasting stations have the RDS transmission and the signal is strong enough.
To save/recall a radio station preset:
1. If DN-700AVP is powered off, press the Power button to power it on.
2. Use the Source Select knob to choose Tuner.
3. Select a radio station using the Tuner -/+ buttons on the unit or the Tuning -/+ buttons on the remote control.
4. Press the Mem button on the remote control, then press the Tuning -/+ buttons to select a preset memory location. Press the Mem
button again to save the radio station to the selected location.
5. To recall a saved radio station, press the Station +/- buttons to cycle through the saved radio station presets.
Playing Audio from the Zone 2 Outputs
You can simultaneously play back the same audio source in both
the Main Zone and Zone 2.
1. Press Zone On/Off to turn on the Zone 2 power.
2. Press Zone Select to map Zone 2 to the desired source input.
3. Play back your audio source.
Note: It is not possible to play digital input signals using the HDMI,
Coaxial, or Optical input for Zone 2.

Connecting to a Network

You can play music files stored on a computer or from Internet radio
stations via your network (LAN).
Required equipment:
•
Broadband Internet connection
•
Modem
•
Router: We recommend using a router equipped with a built-in
DHCP server and a built-in 100BASE-TX switch. When
connecting multiple devices, we recommend a switching hub
with a speed of 100 Mbps or greater.
•
Ethernet cable (CAT-5 or greater recommended): Use only a
shielded STP or ScTP LAN cable.
If you are using an Internet service on which network settings are
made manually or with no DHCP function, adjust the settings
directly from the Network Setup menu. When adjusting network
settings manually, confirm the settings with your network
administrator.
Do not connect the Ethernet cable from DN-700AVP directly to
the LAN port/Ethernet connector on your computer.
1. Connect your Ethernet cable from DN-700AVP to your network.
2. Turn on DN-700AVP. DN-700AVP will connect automatically on
networks with DHCP.
When connecting to a network that has no DHCP function,
manually adjust the settings in the Network Connect menu.
10
Internet
WAN
Router
Computer
Modem
To LAN port
LAN port/
To LAN port
Ethernet
port