Set Date And Time Zone; Set Speaker Volume; Using The Keypad; Using The Control Panel - Honeywell HX3 User Manual

Set Date and Time Zone

Click the Start > Settings > Control Panel > Date/Time icon.
Set Date, Time, Time Zone, and assign a Daylight Savings location on the HX3 after a warm boot or anytime.
There is very little functional change from standard desktop PC Date/Time Properties options. Adjust the settings and click
the OK button or the Apply button to save changes to the registry. Any changes take effect immediately.
Double-clicking the time displayed in the Taskbar causes the Date/Time Properties screen to appear.

Set Speaker Volume

The speaker is on the front, above the white key.
Speaker volume can be adjusted to a comfortable level for the listener by using the keypad or by changing parameters in
the Volume & Sounds control panel.

Using the Keypad

Note: Volume & Sounds (in Settings > Control Panel) must be enabled before the following key sequences can adjust
the volume.
Note: The volume is increased or decreased one step each time the volume key sequence is pressed.
Note: To adjust speaker volume use the Blue+White keys and Blue+Green keys to adjust volume until the speaker
volume is satisfactory.
Volume control using a keypad key press has six volume settings that match those supported by the Volume and
Sounds Control panel. Volume does not "roll-over" from minimum to maximum or from maximum to minimum.
Continuously holding down the up or down arrow keys does not cause an automatic repeat of the up (or down) arrow
key.

Using the Control Panel

Note: When the HX3 is connected via ActiveSync to a PC running LXEConnect, the Volume and Sounds option in the
Control Panel can be used to adjust volume.
Tap Start > Settings > Control Panel > Volume & Sounds > Volume tab. Change the volume setting and tap OK to
save the change.
You can also select / deselect sounds for key clicks and screen taps and whether each is loud or soft.
As the volume scrollbar is moved between Loud and Soft, the HX3 emits a tone each time the volume increases or
decreases.

Using the Input Panel / Virtual Keyboard

The virtual keyboard is always available when needed e.g., text entry.
Place the cursor in the text entry field and, using the stylus:
• Tap the Shift key to type one capital letter.
• Tap the CAPS key to type all capital letters.
• Tap the áü key to access symbols.
Some applications do not automatically display the Input Panel. In this case, do the following to use the Input Panel:
• Move the cursor into the text entry field when you want to enter data using the Input Panel.
• When finished entering data, tap the icon in the Taskbar again.
2 - 12