Honeywell HX3 User Manual page 167

Parameter Default
Auth Timeout 8 seconds
Certs Path System
Ping Payload 32 bytes
Ping Timeout ms 5000
Ping Delay ms 1000
Description
Specifies the number of seconds the Summit software waits for an EAP
authentication request to succeed or fail.
If the authentication credentials are stored in the active profile and the
authentication times out, the association fails. No error message or
prompting for corrected credentials is displayed.
If the authentication credentials are not stored in the active profile and the
authentication times out, the user is again prompted to enter the credentials.
Options are: An integer from 3 to 60.
A valid directory path, of up to 64 characters, where WPA Certificate Authority
and User Certificates are stored on the mobile device when not using the
Windows certificates store. Ensure the Windows folder path currently exists
before assigning the path in this parameter. See
instructions on obtaining CA and User Certificates.
Options are: none.
For example, when the valid certificate is stored as My Computer/System/
MYCERTIFICATE.CER, enter System in the Certs Path text box as the
Windows folder path.
Maximum amount of data to be transmitted on a ping.
Options are: 32 bytes, 64, 128, 256, 512, or 1024 bytes.
The amount of time, in milliseconds, that a device will be continuously pinged.
The Stop Ping button can be tapped to end the ping process ahead of the
ping timeout.
Options are: Any number between 0 and 30000 ms.
The amount of time, in milliseconds, between each ping after a Start Ping
button tap.
Options are: Any number between 0 and 30000 ms.
Certificates (page 9-32) for
9 - 15