Panasonic KX-TGL460 Operating Instructions Manual page 46

Caller ID Service
4
MCELLN
R The unit starts dialing immediately in
the following situations.
– Only 1 cellular phone is paired.
– A specific line is set to make cellular
calls (page 19).
5
MbN: Select the desired cellular phone. a
MSELECTN
n Using a landline
1
MEN (Redial/CID)
R If the redial list is displayed, press MEN
(Redial/CID) again to switch to the
caller list.
2
Press MCN to search from the most recent
call, or MDN to search from the oldest call.
3
To call back, press M
To exit, press MOFFN.
Note:
R If the entry has already been viewed or
answered, " " is displayed.
R or indicates the caller information
was received from the cellular line.
Editing a caller's phone number
You can edit a phone number in the caller list
by removing its area code and/or the long
distance code "1".
n When a cellular phone is paired:
1
MEN (Redial/CID)
R If the redial list is displayed, press
MEN (Redial/CID) again to switch to
the caller list.
2
MbN: Select the desired entry. a
MSELECTN
3
Press * (Edit) repeatedly until the
phone number is shown in the desired
format.
4
Using a cellular line:
To make a cellular call, continue from
step 4, "Viewing the caller list and
calling back", page 45.
Using a landline:
M /ZN
For assistance, please visit http://shop.panasonic.com/support
46
TGL46x(en)_1118_ver044.pdf
n When a cellular phone is not paired:
Caller ID number auto edit feature
/ZN.
Once you call back an edited number, the unit
which was used to call back remembers the
area code and format of the edited number.
The next time someone calls from the same
area code, caller information is customized by
the unit as follows:
– When the call is being received, the Caller
– After the call has ended, the caller's phone
For example, you can use this feature to set
the unit to ignore the area code of callers in
your area, so that you can call these local
numbers using caller information without
dialing the area code.
To activate this feature, you must edit an entry
in the caller list, then call that number. After
that, phone numbers from that caller's area
code are edited automatically.
This feature can be set for each unit
(page 39). The default setting is "On".
Note:
R Phone numbers from the 4 most recently
46
1
MEN (Redial/CID)
R If the redial list is displayed, press
MEN (Redial/CID) again to switch to
the caller list.
2
MbN: Select the desired entry. a
MMENUN
3
MbN: "Edit" a MSELECTN
4
Press MEDITN repeatedly until the
phone number is shown in the desired
format.
5
M /ZN
ID number is displayed in the same format
as the edited number.
number is displayed in the same format as
the edited number, when reviewed from the
caller list.
edited area codes are automatically edited.
2015/11/18 9:33:32