Panasonic KX-TGL460 Operating Instructions Manual page 40

Programming
Main menu: "Key detector"
Sub-menu 1
Search
Battery check
*1 If you program these settings using one of the units, you do not need to program the same
item using another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 When the cellular line only mode is turned on, these menus are not displayed (page 18).
*4 After the Bluetooth device is paired, the device name is displayed.
*5 For CELL 1
*6 For CELL 2
*7 The preset melodies in this product ("Tone 3" - "Melody 10") are used with permission of
© 2004 - 2013 Copyrights Vision Inc.
*8 The preset melodies in this product ("Tone 1" and "Tone 2") are used with permission of
© 2013 Copyrights Vision Inc.
*9 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select "Caller ID auto". To turn this feature off, select
"Manual". (Caller ID subscribers only)
To use this feature, set the date and time first (page 14).
*10 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (tone 1 or
2). If you select a melody, you cannot distinguish lines by their ringers.
*11 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select "On", the tone sounds 2 times.
*12 This setting is available when you have the key detector (KX-TGA20). Read the installation
manual for more information on the key detector.
*13 For models with supplied key detectors, the display shows "1: Detector1".
*14 If you register 2 or more key detectors.
*15 If you subscribe to a Caller ID service and want to view the caller's information after lifting up
the handset to answer a call, turn off this feature.
*16 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary. The setting should stay at "700 ms" unless pressing MACCEPTN fails
to pick up the waiting call.
*17 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to "A" if telephone line condition is not good.
For assistance, please visit http://shop.panasonic.com/support
40
TGL46x(en)_1118_ver044.pdf
*12
Sub-menu 2
–
–
40
Settings Code
– #655
–
2015/11/18 9:33:31
–