Advertisement
SYMBOL DS3508
1
2
OPTIMUM UPRIGHT BODY POSTURE
Optimum Body Posture
for Low Scanning
72-67131-02 Revision A June 2004
SYMBOL DS3508
© 2009 MOTOROLA, INC. All rights reserved..
Motorola reserves the right to make changes to any product to improve
reliability, function, or design. Motorola does not assume any product liability
arising out of, or in connection with, the application or use of any product,
circuit, or application described herein.
No license is granted, either expressly or by implication, estoppel, or
otherwise under any patent right or patent, covering or relating to any
combination, system, apparatus, machine, material, method, or process in
which Motorola products might be used. An implied license exists only for
equipment, circuits, and subsystems contained in Motorola products.
MOTOROLA, the Stylized M Logo and Symbol and the Symbol logo are
registered trademarks of Motorola, Inc. Other product names mentioned in
this manual may be trademarks or registered trademarks of their respective
companies and are hereby acknowledged.
Warranty
For the complete Motorola hardware product warranty statement, go to:
http://www.motorola.com/enterprisemobility/warranty.
Patents
This product is covered by one or more patents. For patent information go to:
http://www.symbol.com/patents.
Service Information
If you have a problem using the equipment, contact your facility's Technical
or Systems Support. If there is a problem with the equipment, they will
contact the Motorola Enterprise Mobility Support at:
http://www.motorola.com/enterprisemobility/support.
For the latest version of this guide go to:
http://www.motorola.com/enterprisemobility/manuals.
Waste Electrical and Electronic Equipment (WEEE)
Türkçe: AB Müşterileri için: Kullanım süresi dolan tüm ürünler geri dönüştürme için
Motorola'ya iade edilmelidir. Ürünlerin nasıl iade edileceği hakkında bilgi için lütfen şu
adresi ziyaret edin: http://www.motorola.com/recycle/weee.
Motorola, Inc.
One Motorola Plaza Holtsville, New York 11742-1300, USA
MOTOROLA and the Stylized M Logo and Symbol and the Symbol logo are registered
in the U.S. Patent and Trademark Office. All other product or service names are the
property of their respective owners.
© Motorola, Inc. 2009
72-124802-01 Rev A June 2009
72-67131-02 Revision A June 2004
SYMBOL DS3508
3
4
1
Tether Plate
2
LED Indicators
3
Scan Window
4
Scan Trigger
AVOID EXTREME WRIST ANGLES
OPTIMUM BODY POSTURE
ALTERNATE LEFT
AVOID BENDING
AND RIGHT KNEES
AVOID REACHING
REGULATORY INFORMATION
Ergonomic Recommendations
Caution: In order to avoid or minimize the potential risk of ergonomic injury follow
the recommendations below. Consult with your local Health & Safety Manager to
ensure that you are adhering to your company's safety programs to prevent
employee injury.
• Reduce or eliminate repetitive motion
• Maintain a natural position
• Reduce or eliminate excessive force
• Keep objects that are used frequently within easy reach
• Perform tasks at correct heights
• Reduce or eliminate vibration
• Reduce or eliminate direct pressure
• Provide adjustable workstations
• Provide adequate clearance
• Provide a suitable working environment
• Improve work procedures.
Regulatory Information
This guide applies to model number DS3508. This device is approved under the
Symbol Technologies brand: Symbol Technologies, Inc., is the Enterprise Mobility
business of Motorola, Inc. ("Motorola").
All Motorola/Symbol devices are designed to be compliant with rules and
regulations in locations they are sold and will be labeled as required.
Local language translations are available at the following website:
http://www.motorola.com/enterprisemobility/support.
Any changes or modifications to Motorola/Symbol Technologies equipment, not
expressly approved by Motorola/Symbol Technologies, could void the user's
authority to operate the equipment.
CAUTION:
Only use Motorola/Symbol approved and UL Listed accessories.
Power Supply
Use only a Motorola/Symbol approved power supply output rated at_5_Vdc and
minimum _0.5_A. The power supplyshall be Listed to UL/CSA 60950-1; and certified
to IEC60950-1 and EN60950-1 with SELV outputs. Use of alternative power
supply will invalidate any approval given to this device and may be dangerous.
Japan (VCCI) - Voluntary Control Council for Interference
この装置は、 情報処理装置等電波障害自主規制協議会 （ＶＣＣＩ） の基準に基づく クラスB情報技術装置です。 この
装置は、 家庭環境で使用することを目的としていますが、 この装置がラジオやテレビジョン受信機に近接して使用さ
れると、 受信障害を引き起こすことがあります。 取扱説明書に従って正しい取り扱いをして下さい。
Korean Warning Statement for Class B ITE
http://www.motorola.com/ds3508
OPTIMUM SCANNING POSITIONS
Aiming
ALTERNATE LEFT AND RIGHT HANDS
ALTERNATE LEFT AND RIGHT HANDS
TAKING BREAKS AND TASK ROTATION RECOMMENDED
TAKING BREAKS AND TASK ROTATION RECOMMENDED
AVOID EXTREME
WRIST ANGLES
Proper Scanning
0 1 2 3 4 5
0 1 2 3 4 5
BEEPER INDICATIONS
Standard Use
Low/medium/high beep
Short high beep
Power up
Bar code decoded
[if decode beeper
enabled]
Parameter Menu Scanning
High/low/high/low beep
High/low beep
Successful
Correct programming
parameter
sequence performed
setting
LED Indications
Off
Green
Scanner is on
Bar code is successfully
and ready to scan,
decoded
or no power to
scanner
Optimum Body Posture for
Extended Range Scanning
Local Contact:
Recommended Usage Guide
Radio Frequency Interference Requirements
Note: This equipment has been tested and
found to comply with the limits for a Class B
Tested to comply
with FCC Standards
digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
FOR HOME OR OFFICE USE
reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Marking and European Economic Area (EEA)
Statement of Compliance
Motorola/Symbol, hereby declares that this device is in compliance with all the
applicable Directives, 8, 2004/108/EC and 2006/95/EC.. A Declaration of Conformity
may be obtained from http://www2.symbol.com/doc
Laser Devices
Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to
Laser Notice No. 50, June 24, 2007 and EN60825-1:2007 and IEC 60825-1(ED.2).
Class 2 laser scanners use a low power, visible light diode. As with any very bright
light source, such as the sun, the user should avoid staring directly into the light
beam. Momentary exposure to a Class 2 laser is not known to be harmful.
Scanner Labeling
COMPLIES WITH 21 CFR1040.10 AND 1040.11 EXCEPT FOR DEVIATIONS
PURSUANT TO LASER NOTICE No. 50, DATED JUNE 24, 2007, AND
CAUTION- CLASS 2 LASER LIGHT WHEN OPEN. DO NOT
STARE INTO THE BEAM. ATTENTION- LUMIÉRE LASER
EN CAS D'OUVERTURE. NE PAS REGARDER DANS LE FAISCEAU.
VORSICHT- LASERLICHT KLASSE 2, WENN ABDECKUNG GEÖFFNET.
NICHT IN DEN STRAHL BLICKEN.
注 意：打开时及联锁失效时有激光辐射 勿直视光束
Recommended Usage Guide
0 1 2 3 4 5
0 1 2 3 4 5
4 long low beeps
Transmission error
detected; data is
ignored
Low/high beep
Incorrect
programming
sequence or
Cancel bar code
scanned
Red
Transmission
error
EN60825-1:2007 AND IEC 60825-1(ED.2).
Advertisement
