Fujitsu DL7400 Installation Manual page 44

Note 2:
In the above step 4, the following screenshot will be displayed if the Trusted Site is not properly
configured. Please follow and complete the steps 4-8 in the section "Pre-setup before sample test print"
10. Once the alignment for printing one AWB is successfully completed, you need to try printing 2-3
pages continuously without tearing off the paper, to verify the alignments are all correct on each
pages. You can repeat steps 1 to 9 above. In step 5 you can select 3 AWBs to print clicking on the
appropriate checkboxes.
11. Once the align is correct for single AWB and multiple AWB printing the Fujitsu Engineer should get
the User to sign-off the Service Report Form.
Installation guide for Fujitsu Dot Matrix Printer_1.6
Print MAWB icon
Select 'Neutral' print type
Page 44