DFI-ITOX G4V620-N User Manual page 76

3
Award BIOS Setup Utility
Wake Up On LAN
If you are using a LAN card that suppor ts the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the system
only through an IRQ or DMA interrupt. Refer to "Wake-On-LAN
Connector" in chapter 2 for more information.
Resume By Alarm
Enabled
Disabled Disables the automatic power-on function. (default)
Date (of Month) Alarm
0
1-31
Time (hh:mm:ss) Alarm
This is used to set the time you would like the system to power-on.
If you want the system to power-on ever yday as set in the "Date
(of Month) Alarm" field, the time set in this field must be later than
the time of the RTC set in the Standard CMOS Features submenu.
76
When Enabled, you can set the date and time you
would like the Soft Power Down (Soft-Off) PC to
power-on in the "Date (of Month) Alarm" and "Time
(hh:mm:ss) Alarm" fields. However, if the system is being
accessed by incoming calls or the network (Resume On
Ring/LAN) prior to the date and time set in these
fields, the system will give priority to the incoming calls
or network.
The system will power-on everyday according to the
time set in the "Time (hh:mm:ss) Alarm" field.
Select a date you would like the system to power-on.
The system will power-on on the set date, and time set
in the "Time (hh:mm:ss) Alarm" field.