AT&T 1739 User Manual page 4

Feature setup
FEATURE
ANNOUNCEMENT
MONITOR
NUMBER
ANNOUNCE
(Please see
NOTE below)
STORE NUMBER
(Please see
NOTE below)
ACCEPT BLOCK
CALLS
(Please see
NOTE below)
AUDIBLE MESSAGE
ALERT
NOTE: For this feature to work, you must subscribe to the caller ID service from your local
telephone company. There may be a fee for this service, and it may not be available in all areas.
SYSTEM
ANNOUNCE
"Announcement
monitor is..."
"Number
announce is..."
"Store number is..."
"Accept block
calls is..."
"Message alert is..."
OPTIONS
• Choose ON to listen to the announcement
when the system answers a call. Choose OFF
to silence your end of the call. (The callers will
still hear the announcement.)
NOTE: Volume must be set to an audible level
to use the announcement monitor.
• When this feature is on, the system will
announce the incoming telephone number
between the second and third rings.
NOTE: When the number announce feature is
on and ring select is set for two rings, the unit
will answer after three rings to allow enough
time for the system to announce the caller's
telephone number.
• When this feature is on, the system announces
the incoming telephone number when it plays
back a message.
• Choose ON to have the system accept all
calls. Choose OFF to have the system respond
to blocked calls with the pre-recorded
announcement, "We're sorry, blocked calls to
this number cannot be accepted," and hang up
without recording a message.
• When this feature is on, the system beeps
every 15 seconds when there are new
messages.