Delete Messages; Message Window Displays - AT&T 1739 User Manual

Operation
Memory is full
When the memory is full, or when 99 messages
have been recorded, F flashes in the message
window. You will then need to delete messages
to make room for new ones. When the memory
is full, the system will answer calls after 10
rings and will beep twice without playing the
outgoing announcement. Enter your remote
access code and delete some or all messages.

Delete messages

Delete messages — Press and hold DELETE.
The system announces "Messages deleted"
and permanently deletes all messages. The
message window displays 0. If there are
unreviewed messages, the system will play an
error tone and will not delete any messages.

Message window displays

DISPLAY
C
0
F
8
9
E
F
0-7
0-98
FUNCTION
Clock needs to be reset or the system is in clock
setting mode.
Flashing — System is recording an announcement
or a memo.
Steady — Announcement playing
—Or—
system is recording a message
—Or—
remote access is in progress.
Rotating — Deleting.
Flashing — Memory is full.
Toll saver is set to 2/4.
Toll saver is set to 4/6.
Feature is on.
Feature is off.
Language is set to English.
Language is set to French.
Volume level appears when volume is adjusted.
Number of messages
(when system is idle).
Delete selected messages — Press DELETE
while the desired message is being played. The
system will delete the message and play the
next message. If you want to replay a message
before deleting it, press MEMO/REPEAT.
When the system reaches the end of the
last message, the messages not deleted are
renumbered and the message window will
then display the total number of messages
remaining in memory.