Star SM-S230I SERIES Hardware Manual page 23

3. To switch the printer mode , press FEED button.
When the printer mode is switched over, the
which mode allows setting change currently.
4. If the current printer mode does not need to be changed, press FEED button again
and switch the printer mode. To change the setting, pre
When the setting is changed, the
is enabled currently.
<A typical operation flow for the steps 3 and 4 above is described below.>
When you want to change the settings of the printer mode as shown below,
<Before> USB / MEDIUM / LOW / NO USE / LOW / NO USE / ON
<After> Bluetooth / MEDIUM / HIGH / NO USE / LOW / NO USE / OFF
① The setting change is enabled as the result of the steps 1 and 2, the
the ERROR lamp
lamp flashing indicates the current setting.
Press the POWER button once. The
changed to Bluetooth.
② Press the FEED button once. The
changed.
③ If you do not change the print density, press the FEED button once more. The
flashes three times and the print speed setting can be changed.
Press the POWER button once. The
HIGH.
④ Press the FEED button once. The
changed.
⑤ If you do not change the BM sensor setting, press the FEED button once more. The
flashes five times and the BM sensor sensitivity setting can be changed.
⑥ If you do not change the BM sensor sensitivity setting, press the FEED button once more. The
lamp flashes six times and the automatic power down mode setting can be changed.
⑦ If you do not change the automatic power down mode setting, press the FEED button once more.
The POWER lamp
Press the POWER button once. The
changed to OFF.
5. After you have configured all of the settings, press and release POWER button and FEED button at
the same time. The new settings will be printed.
If the settings were not configured correctly, follow the above procedure to configure the settings
again.
ERROR lamp
flashes once. The number of flash(s) made by the
ERROR lamp
POWER lamp
ERROR lamp
POWER lamp
flashes seven times and the Auto Connection function setting can be changed.
ERROR lamp
POWER lamp flashes. The number of flashes indicates
flashes. The number of flashes indicates which setting
flashes twice and the communication mode is
flashes twice and the print density setting can be
flashes once and the print speed is changed to
flashes four times and the BM sensor setting can be
flashes twice and the Auto Connection function is
- 16 -
ss POWER button.
POWER lamp flashes once and
ERROR lamp after the
POWER lamp
POWER lamp
POWER
POWER