Star SM-S230I SERIES Hardware Manual page 22

Follow the procedure below to change the printer settings.
POWER lamp: Blinks by the number of cycles corresponding to the mode selected
POWER button: Changes the setting.
1. Press and hold the POWER button for approx. 5 seconds, and printer is turned on.
2. To put the printer into Memory Switch Setting mode, press and hold both the POWER button and
FEED button. After the
buttons after you surely confirm the lamp flashes five (5) times, to get a printer into the setting mode.
CAUTION
Before changing the memory switch settings, make sure that the communication with a host
device is disconnected.
When the printer is under the Bluetooth communication with a host device, it cannot enter the
Memory Switch Setting mode.
by the FEED button.
ERROR lamp: Blinks by the number of cycles corresponding to
the setting selected by the power button.
FEED button: Changes the printer mode.
ERROR lamp flashes five (5) times, you can configure the settings. Release the
* The numbers of blinks made by these lamps
are indicated in the relevant columns in
the memory switch setting table.
- 15 -