Battery; Replacing The Battery - Dell Dimension 9150 Owner's Manual

Battery

Replacing the Battery

CAUTION:
Product Information Guide.
NOTICE:
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer.
A coin-cell battery maintains computer configuration, date, and time information. The battery can
last several years.
If you have to repeatedly reset time and date information after turning on the computer, replace
the battery.
CAUTION:
same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions.
To replace the battery:
1 Record all the screens in system setup (see page 113) so that you can restore the correct
settings in step 10.
2 Follow the procedures in "Before You Begin" on page 63.
3 Remove the computer cover (see page 68).
4 Locate the battery socket.
NOTICE:
board with the object. Ensure that the object is inserted between the battery and the socket before you
attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or
by breaking circuit traces on the system board.
5 Remove the battery by carefully prying it out of its socket with your fingers or with a blunt,
nonconducting object such as a plastic screwdriver.
6 Insert the new battery into the socket with the side labeled "+" facing up, and snap the
battery into place.
106
Removing and Installing Parts
Before you begin any of the procedures in this section, follow the safety instructions in the
To prevent static damage to components inside your computer, discharge static electricity
A new battery can explode if it is incorrectly installed. Replace the battery only with the
If you pry the battery out of its socket with a blunt object, be careful not to touch the system