Greasing - Zenith ABV341 Series Service Manual

MAINTENANCE/INSPECTION PROCEDURE

5-2) Greasing

(1) Greasing guidelines
Apply grease, with a cleaning patch. Do not use excess
grease. It may come into contact with the tape path or
drive system. If this occurs wipe off any excess and
clean with cleaning patch using Isopropyl Alcohol.
NOTE:Greasing Points
1) Loading Path Inside & Top side
2) Tension Base Boss inside Hole
3) F/L Arm Assembly "U" Groove
4) Take-up Arm Rubbing Section
5) L/D Motor Gear Wheel Part
2
1
6
Chassis (Top)
Gear Part
Sector Gear
Loading Base
(L) Side Bracket
6) Shaft
7) F/L Arm Assembly of Buming
Inside Hole
8) S Reel, T Shaft (G381:Yellow)
9) Brake T Groove
4
3
5
Cam Gear
Drive Gear
Guide Rail
Door Bracket Assembly
(2) Periodic greasing
Grease specified locations every 5,000 hours.
1) Loading Path Inside & Top side
2) Shaft
3) F/L Gear Rack Moving Section
4) Shaft
3
4
6
Chassis (Bottom)
F/L Guide Rack
4-21
5) Tension Lever Groove
6) D33 Clutch Assembly Shaft
7) "S" Brake Rubbing Section
2
7
5
F/L Gear Rack
1
8