Threading Welding Wire - Miller Electric OM-1313 Owner's Manual

2-13. Threading Welding Wire

Open pressure assembly.
Close and tighten pressure
assembly, and let go of wire.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle.
6 in
(150 mm)
Pull and hold wire; cut off end.
.
Use pressure indicator
Tighten
scale to set a desired
drive roll pressure.
Pressure
1
Indicator
2
3
Scale
4
Remove gun nozzle and contact tip.
Tighten
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
Tools Needed:
Push wire thru guides into gun;
continue to hold wire.
1
2
3
4
Cut off wire. Close
and latch door.
Ref. ST-801 570-A / ST-801 083 / S-0627-A
4 in
(102 mm)
Turn On.
OM-1313 Page 11