Table of Contents
Advertisement
As you signal a turn or a lane change, if the arrows don't
flash but just stay on
as
you signal a turn or lane change,
a signal bulb may be burned out and other drivers won't
see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when you
signal
a
turn, check the fuse (see "Fuses and Circuit
Breakers" in the Index).
Headlamp High/Low-Beam Changer
To change the headlamps
from low beam to high or
high to low, pull the turn
signal lever all the way
toward you. Then release it.
When the high-beams headlamps are on, this light on
the instrument panel also will be on.
Windshield Wipers
I
1
I
I
i
You can control the windshield wipers by turning the
band with the wiper symbol on it.
For
a
single wiping cycle, turn the band to MIST. Hold
it there until the wipers start, then let go. The wipers will
stop after one cycle. If you want more cycles, hold the
band on MIST longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to LO, the shorter the delay.
2-46
Advertisement
Table of Contents
