Section 1 - Safety Precautions And Signal Words; General Information And Safety; Safety Alert Symbol And Signal Words; Section 2 - Specifications - Miller Electric KC237900 Owner's Manual

SECTION 1 – SAFETY PRECAUTIONS AND SIGNAL WORDS

1-1. GENERAL INFORMATION AND SAFETY

A . General
Information presented in this manual and on various la-
bels, tags, and plates on the unit pertains to equipment
design, installation, operation, maintenance, and
troubleshooting which should be read, understood, and
followed for the safe and effective use of this equipment.
The nameplate of this unit uses international symbols
for labeling the front panel controls. The symbols also
appear at the appropriate section in the text.
B . Safety
The installation, operation, maintenance, and trouble-
shooting of arc welding equipment requires practices
and procedures which ensure personal safety and the
safety of others. Therefore, this equipment is to be in-
stalled, operated, and maintained only by qualified per-
sons in accordance with this manual and all applicable
codes such as, but not limited to those listed in the Arc
Welding Safety Precautions in the welding power
source Owner's Manual.
*Add 2-5/8 in. (67mm) For Lifting Eye
SECTION 2 – SPECIFICATIONS
22-1/4 in.
(565 mm)
35-3/4 in.
(908 mm)
Figure 2-1. Overall Dimensions And Mounting Hole Layout
1-2. SAFETY ALERT SYMBOL AND SIGNAL
WORDS
The following safety alert symbol and signal words are
used throughout this manual to call attention to and
identify different levels of hazard and special instruc-
tions.
This safety alert symbol is used with the signal
words WARNING and CAUTION to call atten-
tion to the safety statements.
WARNING statements identify procedures or
practices which must be followed to avoid seri-
ous personal injury or loss of life.
CAUTION statements identify procedures or
practices which must be followed to avoid minor
personal injury or damage to this equipment.
IMPORTANT statements identify special instructions
necessary for the most efficient operation of this equip-
ment.
16-1/2 in.*
(419 mm)
B
A
3/4 in. (19.0 mm)
Dia. (1 Hole)
5/8 in. (15.9 mm)
Dia. (2 Holes)
H
Mounting Hole Dimensions
Inches Millimeters
A 10
B 8-1/8
C 1
D 35-3/4
E 33-3/4
F 7-1/2
G 15
H 11-1/8
9/32 in. (7.1 mm) Dia. (6 Holes)
C
D
E
F
G
OM-530 Page 1
254.0
206.4
25.4
908.1
857.3
190.5
381.0
282.6
ST-059 587-A