M7: Clutch Adjustment - Cobra PW3 2003 Owner's Service Manual

NOTE: Remove the preload sleeve but leave the spring in for the measurement.
3. Install the preload sleeve.
4. Install and depress the white cap while installing the spring clip.
5. Fork may be reinstalled.

M7: Clutch Adjustment

Tools required
6 mm hex key (Allen wrench)
large flat blade screw driver
Process
1. Remove the clutch adjustment access plug (6mm hex key).
2. Using the kick lever, turn the engine over (rotate the crank) until one of the
large flat head screws is visible through the access hole (this flat head screw
is one of the three adjusters).
NOTE: Turning the adjusting screw Counter Clock Wise (CCW) will allow the
shoe to engage at a lower RPM, this is the direction you should adjust to
compensate for shoe wear. Alternatively, a Clock Wise (CW) adjustment of the
screw will allow the clutch to engage at a higher RPM.
3. Subsequently use the kick lever to rotate the crank and expose the other two
clutch shoe adjusters and adjust them by the same amount.
CAUTION:
Be sure to adjust each of the three shoe adjustors by the same amount.
4. Reinstall the clutch adjust access plug (10 ft-lb, 14 Nm).
Figure 8
16