M4: Rear Brake Adjustment; M5: Air Filter Cleaning - Cobra PW3 2003 Owner's Service Manual

M4: Rear brake adjustment

Tools recommended for rear brake maintenance:
• 10mm open end wrench
There are 2 adjustments on the brake.
Figure 6, adjust brake lever free height Figure 7, adjust lever 'free play'
From the brake lever:
4. Loosen the 10mm nut on the back of the brake pedal.
5. Adjust the bolt to desirable position
6. Tighten the 10mm nut.
From the brake hub:
1. Adjust the wing nut up to desirable position.
CAUTION:
If you tighten the wing nut up too much, the brakes may remain engaged. If so,
the brake pads will burn up, and need replaced.

M5: Air Filter Cleaning

Tools recommended for air filter maintenance:
• #2 Phillips head screwdriver
• 4 mm hex key (Allen)
• Foam filter oil
Procedure
1. Removed the seat with the 4 mm hex key
2. Remove the two Phillips head screws holding the filter to the entrance of the
airbox.
3. Clean the filter in a nonflammable solvent to remove the filter oil.
4. Clean the filter in hot soapy water to remove all dirt particles.
5. Allow to dry thoroughly.
6. Saturate with filter oil and remove excess.
14